Drawing a TRUE Involute spur Gear - Printable Version +- DeltaCad User's Group Forums (http://www.deltacadusersgroup.org/Forums) +-- Forum: Help Desk (http://www.deltacadusersgroup.org/Forums/forumdisplay.php?fid=16) +--- Forum: Tutorial Comments (http://www.deltacadusersgroup.org/Forums/forumdisplay.php?fid=24) +--- Thread: Drawing a TRUE Involute spur Gear (/showthread.php?tid=344) Pages:
1
2
|
Drawing a TRUE Involute spur Gear - Admin 1 - 03-02-2011 Discuss and comment on <this> tutorial here. RE: Drawing a TRUE Involute spur Gear - RandyN - 04-12-2011 I44troll, Thanks for the gear training tutorial. I'm slow finishing part-one but I wanted to take extra time for the concepts to sink in. I do have a question about figure 14. In the paragraph it says RE: Drawing a TRUE Involute spur Gear - i44troll - 04-12-2011 Randy, Once again thanks for participating in the tutorial! I went ahead and edited the text to say RE: Drawing a TRUE Involute spur Gear - RandyN - 04-12-2011 I understand, Thanks Chris "i44troll". Randy RE: Drawing a TRUE Involute spur Gear - Admin 1 - 04-15-2011 Chris, Is this an edit that should be done in the PDF that I didn't catch? RE: Drawing a TRUE Involute spur Gear - i44troll - 04-15-2011 Boss, It's not too critical but if the pdf's can be edited easily it wouldn't hurt to update occasionally based on how others read and interpret the text. RE: Drawing a TRUE Involute spur Gear - Brock - 07-28-2017 Greetings Gents. I have been reading this gear drawing thread, and am slightly confused as to the location of the Gear-Maker Macro. I do have a couple of gears I want to draw, and want to try the macro. I am new to the cad drawing and wish to understand the process better. Brock RE: Drawing a TRUE Involute spur Gear - AlwMVMO - 07-28-2017 I found my copies of Makegear.bas and Gears.bas Macro. Just click on the attachments below. [attachment=570] [attachment=569] Move or Copy these files to your DeltaCad Macros folder then go to the Macro tab in DeltaCad to Run or Edit the Macros. P.S. I tried to add the Timer command in Gears.bas to slow down the animation but it kept crashing. So I added another loop in the Delay subroutine. Code: Sub Delay RE: Drawing a TRUE Involute spur Gear - Brock - 07-30-2017 Thankyou kindly for the quick response. Brock RE: Drawing a TRUE Involute spur Gear - Brock - 08-08-2017 I have just tried the Makegear macro to do a single gear as per the example in the tutorial, only to find that it generates an error in line 95. I think it may be a divide by zero error. |