04-05-2016, 01:56 PM
DeltaCAD always insists on prints 2 copies...even though I don't tell it to print an extra copy. I end up with 2 identical sheets.
Another issue I have is printing ARCH size sheets. When I try, DeltaCAD always messes up...it insists on drawing it wrong. If I tell it 11x17, it prints perfectly...however, it won't print 12x18 correctly? I cannot get it to print properly. It either prints it as 8.5x11 or it prints it too large. Why does DeltaCAD not properly support ARCH size sheets?
Another issue...I figured out what the problem was, it wasn't addressed in the frequently asked questions. If the border for text goes outside the drawing limits, it will cause strange results...like the drawing not fitting on the sheet. Just something that could be added to the FAQ in case anyone else runs into this issue.
Another issue I have is printing ARCH size sheets. When I try, DeltaCAD always messes up...it insists on drawing it wrong. If I tell it 11x17, it prints perfectly...however, it won't print 12x18 correctly? I cannot get it to print properly. It either prints it as 8.5x11 or it prints it too large. Why does DeltaCAD not properly support ARCH size sheets?
Another issue...I figured out what the problem was, it wasn't addressed in the frequently asked questions. If the border for text goes outside the drawing limits, it will cause strange results...like the drawing not fitting on the sheet. Just something that could be added to the FAQ in case anyone else runs into this issue.