It's hard to know what is going on. Here are some things to look at.
1. When you send a drawing to the printer does a printer icon show up in the notification area at the right end of the taskbar?
2. If you click on it does it show it is printing 1 or 2 pages?
3. Have you tried different parameters in the Set Print Region settings?
4. Have you tried reinstalling the printer driver?
5. What printer are you using?
6. Can you post a screenshot of the drawing, a screenshot of the Set Print Region settings and a screenshot of the preview?
7. Try running Deltacad in XP Compatibility Mode.
The Set Print Region settings screenshot I attached was for a 8.5 x 11.0, and it says it is going to print 8.267717 x 10.748031
so sometimes it is not going to do exactly what you think it is going to do.
1. When you send a drawing to the printer does a printer icon show up in the notification area at the right end of the taskbar?
2. If you click on it does it show it is printing 1 or 2 pages?
3. Have you tried different parameters in the Set Print Region settings?
4. Have you tried reinstalling the printer driver?
5. What printer are you using?
6. Can you post a screenshot of the drawing, a screenshot of the Set Print Region settings and a screenshot of the preview?
7. Try running Deltacad in XP Compatibility Mode.
The Set Print Region settings screenshot I attached was for a 8.5 x 11.0, and it says it is going to print 8.267717 x 10.748031
so sometimes it is not going to do exactly what you think it is going to do.