Boss,
I didnt think anyone was dissing me
, just thought people were way over concerned about the use of decimal fractions
, that's all. Decimal fractions are needed when dealing with very small drawings, and not needed at all in large drawings, but this would be more clearly seen as users switch from drawing furniture to, say, jewelry.
I must correct something that I mentioned in the previous posting. I said "......Notice that Deltacads scale selection only goes up to 128......" When it actually goes up to 500! Scale is listed in two areas on that page, while some numbers are listed as "the ratio of a foot" others are just listed by "even tenths or hundredths". Sorry for the misrepresentation.
Chris
I didnt think anyone was dissing me
, just thought people were way over concerned about the use of decimal fractions, that's all. Decimal fractions are needed when dealing with very small drawings, and not needed at all in large drawings, but this would be more clearly seen as users switch from drawing furniture to, say, jewelry. I must correct something that I mentioned in the previous posting. I said "......Notice that Deltacads scale selection only goes up to 128......" When it actually goes up to 500! Scale is listed in two areas on that page, while some numbers are listed as "the ratio of a foot" others are just listed by "even tenths or hundredths". Sorry for the misrepresentation.
Chris