11-19-2021, 04:59 AM
Hi there,
I've searched the manual and the forums for a way to divide a line into equal segments and not found anything, which is surprising. Perhaps it's there but it's not called dividing? I found the split line function but that seems to require manually placing the point (or snapping to an existing point/line).
In the particular case I'm looking at I need to divide a line into 3 equal segments. This could be done by splitting the line into three or adding two points at the 1/3 and 2/3 marks, so I can snap to them. More generally I do need a way to divide lines into N equal parts.
I'm new to DeltaCAD so still learning my way around. Sorry if this is covered somewhere already.
Thank you,
David.
I've searched the manual and the forums for a way to divide a line into equal segments and not found anything, which is surprising. Perhaps it's there but it's not called dividing? I found the split line function but that seems to require manually placing the point (or snapping to an existing point/line).
In the particular case I'm looking at I need to divide a line into 3 equal segments. This could be done by splitting the line into three or adding two points at the 1/3 and 2/3 marks, so I can snap to them. More generally I do need a way to divide lines into N equal parts.
I'm new to DeltaCAD so still learning my way around. Sorry if this is covered somewhere already.
Thank you,
David.