07-12-2010, 03:04 AM
I downloaded it and tried it out. works great!! thanks
Macro to plot multiple X and Y coordinates?
|
07-12-2010, 03:04 AM
I downloaded it and tried it out. works great!! thanks
Hey "SBUCHER",
"CLYDESDALE" has come though once again and improved on the originanal file offering by adding the ability for it to read 'standard' (single line) x,y coordinates! Here's what he said... Quote:Hello, Boss: The new version, "Multi-Point Plotter2", is now available for download along with additional data samples and updated instructions on the 'shared file card', which is next to the original first version. Personally, I can't thank "CLYDESDALE" enough for taking the time to fill this request. I think an award nomination is in order, eh? OHHH....! AND a higher star rating for this thread may be in order too. I've applied my one allotted star rating vote already, so it's up to the rest of you to "boost it up", if you think it deserves boosting, that is. (Yes, Even as admin, I can't 'force' a thread rating up or down. I only have one vote just like everyone else.
05-06-2014, 10:05 AM
The DeltaCad Macro system does allow input from a comma delimited data
2.31, 5.2 (new line) 10.1, 8.6 (new line) with Code: Input #1, cx, cy and if you put these 2 lines after the dcCreatePoint line in the' Multi-Point Plotter.bas' Macro it will create a line entity between each point Code: If S=1 then dcCreateLine cx, cy, Xb, Yb |
« Next Oldest | Next Newest »
|